BSBOHS404B contribute to the implementation of strategies to control Coursework

BSBOHS404B contribute to the implementation of strategies to control OHS risk - Coursework ExampleHowever, for a mobile crane to shift for registration, it must have a rating capacity greater than 10 t. In addition, before registration, the mobile crane in question must tolerate thorough inspection by a competent person. Further, mobile crane owners are undeniable to ensure that cranes are in good condition completely the time. accord to Workplace Health and Safety Regulation 211 essentials, registration of mobile cranes is done on January 31 every year (The State of Queensland par. 3).Even though there has always been a requirement for the registration of air conditioning units, this requirement was crapped under WHS Regulation 2011. This implies that there is no longer a requirement for the registration of an air conditioner (The State of Queensland 36).Like fired pressure that must be registered under, WHS Regulation 2011, the same applies to unfired pressure vessels. Regist ration of unfired pressure vessel is required under the regulation to ensure that it is in good condition and does not pose health and golosh risk to workers. In fact, before registering unfired pressure vessel, a thorough investigation is conducted by a competent person to ensure that the vessel meets the health and safety requirements. Compliance with the health and safety regulations aims to guarantee safety and health of workers using the vessel (State of Queensland 23).An air compressor go under pressure vessels, which require registration under schedule 5, Part 2 of WHS Regulation 2011. According to this regulation, any pressure vessel classified as hazard level A, B, or c must be registered. An air compressor is one of the pressure vessels that falls under these categories, thus must be registered. To qualify for registration, the threshold for the compressor design must be Volume x Design Pressure_ 30MPa.L. Once the threshold is met, and then the supplier of the air compr essor must ensure that its design is registered with the